Hello,
In my company we are considering if it is possible to adapt servomotors from Siemens in our machines. I have TIA Scout v4.4 on a laptop but I do not have courses on this software.
Where should I start? I would like to learn also ST since I do understand SCL and STL. Also I would like to do the dimensioning of the units and the mechanical parts.
The courses are way to expensive since we are only considering it.
Thanks,
Bruno
In my company we are considering if it is possible to adapt servomotors from Siemens in our machines. I have TIA Scout v4.4 on a laptop but I do not have courses on this software.
Where should I start? I would like to learn also ST since I do understand SCL and STL. Also I would like to do the dimensioning of the units and the mechanical parts.
The courses are way to expensive since we are only considering it.
Thanks,
Bruno