You are not registered yet. Please click here to register!

plc storereviewsdownloads
This board is for PLC Related Q&A ONLY. Please DON'T use it for advertising, etc.
Try our online PLC Simulator- FREE.  Click here now to try it.

---------->>>>>Get FREE PLC Programming Tips

New Here? Please read this important info!!!

Go Back - Interactive Q & A > - Interactive Q & A > LIVE PLC Questions And Answers

PLC training tools sale

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old December 20th, 2017, 09:44 AM   #1
Lifetime Supporting Member
United States

sjohnson is offline
sjohnson's Avatar
Join Date: Feb 2010
Location: MI
Posts: 207
GE FANUC VersaMax IC200UEM001

Good Day and Merry Christmas.. I have a IC200UDR140 Fitted with a IC200UEM001 Ethernet Module. I am looking at setting up Modbus/TCP communications. I have set up the Ethernet Module with the Modbus Driver with PumpKIN not sure if it is correct but can post a screenshot. But first question I have is
1.) There is different instruction in the GFK-1645L section 14.6. not the same COMM_REQ I am accustomed to in the 9030 and RX3i Modbus /TCP it has the MODBUS TCP RW instruction. Not familiar with this and is the only manual that explains this just in the few short sections of the 1645L manual. Is there a separate communications manual or Modbus /TCP or Ethernet manual like the rx3i or 9030.
2.) Reading the Excerpt From :HERE
and what I read in the GFK-2436H that the Ethernet module is a passthrough or bridge. Because on the Hardware Settings and the Port 2 Ethernet Tab it is setup as RTU. I am going from a 9030 with a Snyder TSXETG100 RTU to TCP Bridge. The document talks about the RTU Serial settings and Station address which is all being setup in the TSXETG100. is this Ethernet module being the bridge from serial to TCP not quite grasping the function here.. thanks.. Regards Shawn
  Reply With Quote
Jump to Live PLC Question and Answer Forum


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Topics
Thread Thread Starter Forum Replies Last Post
Automation Direct & GE Fanuc VersaMax Micro: 24VAC On 24VDC Inputs? kittydog42 LIVE PLC Questions And Answers 7 May 1st, 2009 05:31 PM
Profibus for Ge Fanuc Versamax MrQ LIVE PLC Questions And Answers 0 September 14th, 2007 01:38 PM
Need Acad Layout for GE Fanuc IC200UAR028 VersaMax PLC ste1171 LIVE PLC Questions And Answers 2 July 5th, 2006 04:09 PM
GE Fanuc VersaMax Easy Program Store Device CaseyK LIVE PLC Questions And Answers 2 September 13th, 2004 06:38 PM
GE Fanuc VersaMax PID control problem Shawn Cassidy LIVE PLC Questions And Answers 6 May 16th, 2004 08:10 AM

All times are GMT -5. The time now is 08:00 AM.