Can someone tell that this configure is working?
1) I'm using WinAC program,
2) Plan to use build-in ethernet card with computer,
to save cost from CP1613, so in HW Config, I will use IE General SW V6.2 SP1 instead.
3) then ET200S, as IM151-3 PN profinet will be input/output to communicate with this Soft PLC.
i'm not sure it's possible to configure like that or not.. and
what software require extra from this?
i already have,
1) Simatic NET CD 2005
2) WinAC 6ES7 611-4PY00-0YB7
3) Step 7 V5.3
Please guide
1) I'm using WinAC program,
2) Plan to use build-in ethernet card with computer,
to save cost from CP1613, so in HW Config, I will use IE General SW V6.2 SP1 instead.
3) then ET200S, as IM151-3 PN profinet will be input/output to communicate with this Soft PLC.
i'm not sure it's possible to configure like that or not.. and
what software require extra from this?
i already have,
1) Simatic NET CD 2005
2) WinAC 6ES7 611-4PY00-0YB7
3) Step 7 V5.3
Please guide