jthornton
Member
I have an application that uses a Keyence camera. I need to communicate with the camera controller via a 232 serial interface. The reason I need to use the serial interface is the controller has the extra memeor chip installed and the only way to change to the extra chip is with the serial commands.
The specs for the camera are:
Can the SLC 5/03 send commands via this serial interface?
Example
Command C S , 1 2 3 cr
Response C S cr
If so can someone point me in the right direction...
If not is there another way to do this?
Thanks
The specs for the camera are:
Full Duplex
Synchronization Start/Stop
Data Format ASCII
Data Length 8 bits
Stop bit length 1 bit
Parity None
Baud Rate 9600/19200/38400
Data Delimiter CR
X Parameter Only with binary data responses
Can the SLC 5/03 send commands via this serial interface?
Example
Command C S , 1 2 3 cr
Response C S cr
If so can someone point me in the right direction...
If not is there another way to do this?
Thanks