omron CPM1A and stepper drive

nadeemalik

Member
N
Join Date
May 2011
Location
pakistam
Posts
6
hello
i m using omron plc and kinco drive to run stepper motor.
i have read all of the omron pulse instructions used in plc proggramming but i could not understand them.

i want a simple example of omron plc program that can run stepper
motor via drive only at specifed frequency and fixed no. of pulses.
 

Similar Topics

T
Documenting an Omron CPM1A program in CX-Programmer
I've got an upload from an Omron SYSMAC CPM1A PLC but I cannot figure out for the life of me how to document the inputs and outputs. It's version...
Replies
9
Views
3,250
technolog
T
L
Omron Cpm1a
Hi, I have recently purchased an old Omron Cpm1a plc to practice on. I have a version of syswin that does not require a licence to program these...
Replies
2
Views
1,658
Lc1
L
C
Omron CPM1A-MAD01 Analog
I have a Omron PLC with CPM1A-MAD01 anaolog input output module its reading pt100 temperature probe. When the machine is running it starts to...
Replies
0
Views
1,088
Carlosol
C
M
Omron CPM1A System Alarm (FAL) Error
Hi, I have recently being using a Omron CPM1A-40CDR-D-V1 and transferred an old program on it. I was testing the program and making some...
Replies
2
Views
4,218
Mat.Hinse
M
L
Omron CPM1A AND NT20S-ST121B-EV3
I have two of the same units that are using a CPM1A and an NT20S-ST121B-EV3. I am not able to connect to the touch screen as far as i can tell via...
2
Replies
16
Views
3,991
gclshortt
gclshortt
Back
Top Bottom