Creating an HOA switch in Lookout HMI

Rmiller

Member
Join Date
Dec 2002
Location
Vancouver, Washington
Posts
25
I am still playing with National Instruments Lookout HMI and have been trying to create a HOA using a "Radio Button" but cannot seem to figure out how or if this is the right graphic to use, any help would be appreciated.
 
"HOA" is short for a "HAND-OFF-AUTO" selector switch...

And, before you ask, "AUTO" is short for "Automatic"... :p

Rmiller, you may want to look at THIS THREAD

beerchug

-Eric
 
Last edited:

Similar Topics

The idea here is to provide for a brief rapid influx of message codes while preventing sequentially repeating the same message. i.e. if two...
Replies
23
Views
428
Hello everyone, In a factory where we installed Citect 7.20 the computer began to show the first signs of end of life. They never considered...
Replies
0
Views
57
Hi everyone, I'm a last year student at the university in Ghent, and for my thesis i need to write a TwinCAT program that writes data to a .daq...
Replies
0
Views
118
When I go to create a new module in Studio 5000 I can't enter any information for the IP Address or change any other fields. Is there any fix to...
Replies
1
Views
238
Hello I am kind of new to the Rockwell world, i've mainly worked with Siemens and Schneider untill now. I am to make a HMI application running...
Replies
7
Views
1,019
Back
Top Bottom