ian.smith7
Member
Hi all hope you can help.
I have installed gx developer v8 into the win 2k partition of hp laptop (dual boot to win 2k/sp4 or win/98 v2). I plugged the laptop into a mitsi A1sJH plc using an sco9 cable but have been unable establish comms. I get a cable fault or mismatch program error.
Using medoc 2.4 on the win 98 partition with the same cable and plc everthing worked fine upload, download & verify.
I read Steve Etters reply to a similar problem with gx developer and from memory i am sure the comms were set ok.
I created an empty program for an A1sJH cpu and tried to establish comms again without success.
I think this may be a win 2k problem, is there something I need to set up. The melsec environment is installed and rs logix 500 works fine on the win 2k partition.
any suggestions gratefully recieved.
cheers
ian smith
I have installed gx developer v8 into the win 2k partition of hp laptop (dual boot to win 2k/sp4 or win/98 v2). I plugged the laptop into a mitsi A1sJH plc using an sco9 cable but have been unable establish comms. I get a cable fault or mismatch program error.
Using medoc 2.4 on the win 98 partition with the same cable and plc everthing worked fine upload, download & verify.
I read Steve Etters reply to a similar problem with gx developer and from memory i am sure the comms were set ok.
I created an empty program for an A1sJH cpu and tried to establish comms again without success.
I think this may be a win 2k problem, is there something I need to set up. The melsec environment is installed and rs logix 500 works fine on the win 2k partition.
any suggestions gratefully recieved.
cheers
ian smith