Omron FZ4-L355 Vision & Profinet

Mike_RH

Lifetime Supporting Member
M
Join Date
Sep 2006
Location
Toronto
Posts
896
Gents,

Does anyone have any experience with this Omron vision system and a Siemens S7-300 CPU using Profinet?

The Omron does not support Profinet, but does support UDP / TCP connections. Has anyone doen this? Or would it be easier to use something like an Anybus adapter?

All comments appreciated!
 

Similar Topics

M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
1
Views
45
Corsair
C
A
Omron cj1m ETN cpu11 connection with NT631C
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Replies
5
Views
77
IO_Rack
IO_Rack
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
42
Ko Lin
K
S
Omron NB Screen & NX1P2 PLC Real Number issue
I am working on a project using a NB screen and NX1P2 PLC. I am having a really hard time getting a real number to properly translate through to...
Replies
3
Views
114
drbitboy
drbitboy
M
OMRON Network Configrator ERROR
Hi, I am facing an error inside Omron Network Configurator. I have 2 PLC communicate each other using ethernet cable, send signal using Network...
Replies
2
Views
96
chelton
C
Back
Top Bottom