Omron FZ4-L355 Vision & Profinet

Mike_RH

Lifetime Supporting Member
M
Join Date
Sep 2006
Location
Toronto
Posts
896
Gents,

Does anyone have any experience with this Omron vision system and a Siemens S7-300 CPU using Profinet?

The Omron does not support Profinet, but does support UDP / TCP connections. Has anyone doen this? Or would it be easier to use something like an Anybus adapter?

All comments appreciated!
 

Similar Topics

BobB
SMS messaging from an Omron CJ2M-CPU31
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
Replies
2
Views
56
lostcontrol
L
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
1
Views
50
IO_Rack
IO_Rack
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
3
Views
89
chelton
C
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
252
KalvMavin
K
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
131
Mihir_007
M
Back
Top Bottom