I'm trying to backup the panelview program on a panelview 1400e.
I'm a complete newbie.
I have a serial cable with a 25 pin on one end.
I have panelview32 software with rslinx.
I connect the serial cable between my pc and the rs232 port on the panelview. (I've tried both a null modem and a straight through cable).
I don't see the terminal in rslinx in either case.
How can I communicate with the panelview?
Does it have to be in configuration mode before it will see the terminal so I can upload the program? The terminal is in run mode and is communicating with the the SLC 5/04.
Will my software talk to this terminal? I see references to a panelview 1200/1400e transfer utility. Do I need this?
When I connect the dh+ to the SLC, rslinx sees the panelview but I can't communicate with it. When I fire up Panvelview32 while connected to the SLC and try to upload from the panelview, it says the device is not a user terminal?
Thanks, in advance.
Tom
I'm a complete newbie.
I have a serial cable with a 25 pin on one end.
I have panelview32 software with rslinx.
I connect the serial cable between my pc and the rs232 port on the panelview. (I've tried both a null modem and a straight through cable).
I don't see the terminal in rslinx in either case.
How can I communicate with the panelview?
Does it have to be in configuration mode before it will see the terminal so I can upload the program? The terminal is in run mode and is communicating with the the SLC 5/04.
Will my software talk to this terminal? I see references to a panelview 1200/1400e transfer utility. Do I need this?
When I connect the dh+ to the SLC, rslinx sees the panelview but I can't communicate with it. When I fire up Panvelview32 while connected to the SLC and try to upload from the panelview, it says the device is not a user terminal?
Thanks, in advance.
Tom