James42005
Member
Hello, I know this has been discussed before but i couldn't find exactly what i was looking for in older posts, here is what i got...
I have a FTV ME project that was created in a 32bit environment with version 5.1 running on a PVP CE 1500. I am using FTV Studio V9. I needed to make some updates to the project and I found out the hard way about the "never convert" selection when creating the runtime. I don't have access to a 32 bit PC to make my changes. It appears the device is discontinued and running the latest firmware. So I have a few questions about my options. I see that Rockwell has rollup patch for Studio V9 to address this issue, can anyone confirm this works? I aslo read somewhere that v10 may also be able to convert runtime back to 5.1, again can anyone confirm? But what i would really like to know, is if anyone has ran FTV Studio in some sort of 32bit mode on a 64bit PC? I am relatively new at this so if there are other easier options to work around this problem please advise.
Thank you.
I have a FTV ME project that was created in a 32bit environment with version 5.1 running on a PVP CE 1500. I am using FTV Studio V9. I needed to make some updates to the project and I found out the hard way about the "never convert" selection when creating the runtime. I don't have access to a 32 bit PC to make my changes. It appears the device is discontinued and running the latest firmware. So I have a few questions about my options. I see that Rockwell has rollup patch for Studio V9 to address this issue, can anyone confirm this works? I aslo read somewhere that v10 may also be able to convert runtime back to 5.1, again can anyone confirm? But what i would really like to know, is if anyone has ran FTV Studio in some sort of 32bit mode on a 64bit PC? I am relatively new at this so if there are other easier options to work around this problem please advise.
Thank you.