Old Siemens Program - Upgrade Controls

RockyLeafs

Member
R
Join Date
Aug 2014
Location
Southwestern Ontario
Posts
80
We have a very old piece of equipment ('97) that a customer would like us to upgrade the controls to Rockwell.

The original program was written in Siemens (Believe ProTool?).
Was wondering if anyone would have the ability to open the program and possible send it back as a PDF.

Otherwise, we are going into the project absolutely new.
I believe we have the .S5D and some other files from the original programming.
 

Similar Topics

R
Old Siemens Program - Upgrade Controls
We have a very old piece of equipment ('97) that a customer would like us to upgrade the controls to Rockwell. The original program was written...
Replies
12
Views
2,356
curlyandshemp
curlyandshemp
Eugen
Old Siemens PLC program
Hello, I need some help with a older machine a Driam coater DRC 1600/1.25, Step 5 Siemens PLC. The program was lost due to a dead battery (I...
Replies
4
Views
3,557
Eugen
Eugen
A
Can I program the old Siemens S5 with Step 7?
Can I program the old Siemens S5 with Step 7? I need to make some small changes to several old Siemens S5 and neither my customer nor I have any...
Replies
4
Views
17,596
format C:
format C:
E
Siemens OP7 OLD Hmi Terminal
Hi Guys, Hoping we still have some Siemens Old hardware Gurus on here. We are trying to support one of our long time customers. Who have obtained...
Replies
4
Views
900
sigmadelta
S
K
replace old Siemens Sinamics S120 by new ones
Kindly, can we install new Siemens Sinamics S120 motor modules and new 1FK7 servomotors, in place of old types ? Will the old motion control...
Replies
0
Views
1,106
Kataeb
K
Back
Top Bottom