2D Data Matrix - separating out data

tspisak

Member
T
Join Date
Aug 2005
Location
Corning, NY
Posts
72
Has anyone read a long 2D data matrix (200+ characters) and separated out the data in to different fields (~twenty)?

I plan on adding a comma to indicate the start of a new field but I don't know where to start programming. The data is a recipe so the data types for each field will stay the same from code to code but the length will not (long and short strings).

I am using a Keyence SR-651 barcode scanner connected to a A-B CompactLogix processor via Ethernet IP.

Any tip on getting started?
 

Similar Topics

Sparky
Data matrix reader configuration
What kind/brand of 2D data matrix readers are the easiest to set up and communicate with CompactLogix PLC? I'm looking to install and setup...
Replies
4
Views
2,211
Sparky
Sparky
E
How to get data from multiple Mitsubishi Q03UDVCPU into master PLC Q03UDVCPU through QJ71E71-100 ?
Hi, How to get data from multiple Mitsubishi Q03UDVCPU into master PLC Q03UDVCPU through QJ71E71-100 ?
Replies
1
Views
44
parky
P
D
FT view studio Failed to load Data Server RNA
When i load my client a[plication the following error is recorded in factorytalk view studio log Failed to load data server...
Replies
0
Views
44
Deanyo1234
D
S
Move data from scada to plc
Hello, im quite new and still learning. I would like to ask is it possible for FATEK PLC to read data value more than 16k? I'm trying to move my...
Replies
0
Views
78
Shak
S
P
Modbus AOI Data transfer
Hello Everyone, I am using a raC_Opr_NetModbusTCPClient AOI module, as below,. So, I need some assistance to restrict in reducing the poling...
Replies
2
Views
151
parithielam15
P
Back
Top Bottom