compact logix to proface

Join Date
Dec 2005
Location
Christchurch
Posts
1
We urgently need to connect a Proface operator display (Proface GP37W2) to a Rockwell compact logix L31 .
We need info on
1.How to set up the addresses/tags in the Compact logix so the proface can read and write data.
We have set up the Proface to read/write N7:00 to N7:50.
If anyone has donne this successfully it would be very helpfull to us to
get some info which will help in getting this done.
Thanks
JA
 
You need to use the PV mapping tool in Contlgx5K to set up the tags.
Use the Logic Pulldown menu and click on Map PLC/SLC messages.
This will set up the direct mapping for the integerst that you have specified.
Check out the manual for using PV tags in contrologix help.
 

Similar Topics

I've blown the Output Transistor on the Output Card of a Compact Logix 1769-L24ER-QBFC1B It says J378. Does anyone know the replacement part...
Replies
3
Views
167
I am having trouble with getting no control of my analog output signal. I am using the SCL function block to control my analog output. The logic...
Replies
11
Views
210
I was wanting to see if anyone had any information on setting up a cub5 meter and getting the data to a Allen bradley PLC. I think i have the set...
Replies
0
Views
110
I had a comms fault between my VFD and Controller (5069-L320ERS2) that started about a month ago and happened maybe once a day to now where it...
Replies
1
Views
242
hi , I need to sorry for my bad English first. I'm newbie at plc programming ,I had been asked about E/IP protocol information for some system...
Replies
3
Views
339
Back
Top Bottom