ACS 550 Modbus communication

Ind Auto

Member
Join Date
Sep 2012
Location
Maha
Posts
2
While communicating from ABB ACS 550 to ABB AC31 PLC through Modbus, it is noted that ACS 550 has address protocol with prefix '4', which renders the address to be beyond 40000 value. Whereas PLC Function block attributes WORD value to the Address input, which cannot be more than 32768. Could anybody help?
 

Similar Topics

Dear All I have acs 550 abb drive and schinder m218 plc so anyone know this communication modbus
Replies
1
Views
3,552
Dear ALL, I am having an old installed ACS 550 drive from yesterday onwards its remote signal is not showing up on CDP even if after pressing...
Replies
0
Views
1,440
How to i run abb make acs 550 in vector mode without encoder... ????
Replies
12
Views
1,964
How can i use ABB acs 550 in vector mode without encoder. ????
Replies
1
Views
1,342
I have a ABB ACS550. I am looking to control this drive via RETA-01 ethernet card by ABB. I have a 1756-L7 controller. I need in addition to the...
Replies
1
Views
1,752
Back
Top Bottom