Transfering from 1200P

Join Date
Apr 2017
Location
Alabama
Posts
10
AB 1200P
6181P

Needing to transfer .cli file from one 1200P to another. I've loaded the file to the new one but it will not open. File name is KM Foam Line but error says "Application 'SeatLin_2011_10_15'" does not exist.

Any help would be appreciated.
 

Similar Topics

Hi guys. I am using RS Studio v24 and I have a structure BOOL[2048] inside. When I give project to our HMI designer he sees that array of bools...
Replies
6
Views
2,158
Hi, I've been trying to run my project in Simulation (and check display on VNC viewer). When I try to download a procjet to simulator, then I...
Replies
2
Views
1,498
Hi All, I've recently gained control of an existing control system used for purifying water. We have an SLC 5/05 processor and are using RSView...
Replies
8
Views
2,973
Everyone, So I have been on this forum for the last 24hours straight. I have learned a ton, like always. Yesterday I posted about resetting all...
Replies
1
Views
2,673
Hi all, I am using WinCC flexable v.2008 Sp2 and transfering project to a MP377 12" Touch HMI via mode ethernet / IP address. My issue is that...
Replies
2
Views
1,501
Back
Top Bottom