ELWOODEOD
Member
Looking for a program example for Omron NX102 processor using sysmac studio to interface with Keyence SR-1000 barcode reader.
SYSMAC Studio and Keyence SR-1000
- Thread starter ELWOODEOD
- Start date
the_msp
Lifetime Supporting Member
Welcome to the forum!
If you go to the website www.barcodereader.com you will find example PLC projects. Unfortunately, there are none available for NX series with SR1K, but there are ones for other models which may help you as a starting point.
If you go to the website www.barcodereader.com you will find example PLC projects. Unfortunately, there are none available for NX series with SR1K, but there are ones for other models which may help you as a starting point.
+1 the_msp
https://www.keyence.com/support/user/barcode/download/connections.jsp
Look at the CJ2 samples with the corresponding interface media.
Regards,
https://www.keyence.com/support/user/barcode/download/connections.jsp
Look at the CJ2 samples with the corresponding interface media.
Regards,
Similar Topics
Hi,
I have been trying to run drive via Sysmac studio. I can ping the drive. I can see the logic bits going on/off as per command. But, drive is...
Good morning to everyone on the forum and happy new year. I'm trying to use the following functions in sysmac studio, because I need to enable one...
Good morning everyone, I'm having difficulty using the "sin" and "cos" functions in sysmac, in particular the results of the functions are not...
Hi everyone,
I am trying to program a function block to copy the variables obtain from Ethercat into a structure on a NX1P2.
Since I cannot...
Hi all, I am trying to transfer my sysmac studio license from my PC to my co-workers pc as he will be the tech installing our new system. The...