Arunkumar G
Member
Hai,
When i am updating the firmware for 1756 EN2T, it got disconnected and now it is not connecting through Ethernet as well as USB.
Only OK Red led blinking, Link and Net LED are in off state
Display shows unprotected mode - change switch settings
I tried protected mode by changing 900 in switch and i rebooted again it is going to unprotected mode
I reset the device using 888 in swutch, still the error exists...
Kindly give a solution
Regards,
Arunkumar G
When i am updating the firmware for 1756 EN2T, it got disconnected and now it is not connecting through Ethernet as well as USB.
Only OK Red led blinking, Link and Net LED are in off state
Display shows unprotected mode - change switch settings
I tried protected mode by changing 900 in switch and i rebooted again it is going to unprotected mode
I reset the device using 888 in swutch, still the error exists...
Kindly give a solution
Regards,
Arunkumar G