Good Evening ,
I am doing a machine modification for a customer and it has a older Panelview Plus on it. I am using 2 shortcuts , one from a Micrologix 1500 (serial) , and another for a Ethernet Compactlogix It is a older RS View Studio application . I did run the FactoryTalk View legacy migration tool , and the application opens up well. The Design and Runtime in the communication setup , has these 2 shortcuts. When I do a "Create Runtime Application" , and after it creates it , I get this "Statement".......
*** Start RSLinx Enterprise Conversion Messages ***
WARNING: Unconfigured shortcut detected. Shortcut name = "1348_Moulder". Description: The system has detected that the noted shortcut has not been associated with a device on the Runtime (Target) tab. If the application makes use of this shortcut, then runtime errors will be detected and logged when the application attempts to use that shortcut.
WARNING: Unsupported device detected. Shortcut name = "Ethernet Shortcut". Device name = "Interbake_Line_4_1348_Molder". Description: The system has detected that a device type that was not supported in the requested version is referenced by a shortcut. If the system upon which this project is to be run has received a patch that adds support for this device type, then this situation will not cause any problems. Otherwise runtime errors will be detected and logged by the target system when it attempts to communicate to that device.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with warnings. The runtime application has been created.
CAUTION: Running this application might produce errors at runtime.
----------------------------------------------------------------------------------------
What would cause this ?
Thanks so much in advance,
I am doing a machine modification for a customer and it has a older Panelview Plus on it. I am using 2 shortcuts , one from a Micrologix 1500 (serial) , and another for a Ethernet Compactlogix It is a older RS View Studio application . I did run the FactoryTalk View legacy migration tool , and the application opens up well. The Design and Runtime in the communication setup , has these 2 shortcuts. When I do a "Create Runtime Application" , and after it creates it , I get this "Statement".......
*** Start RSLinx Enterprise Conversion Messages ***
WARNING: Unconfigured shortcut detected. Shortcut name = "1348_Moulder". Description: The system has detected that the noted shortcut has not been associated with a device on the Runtime (Target) tab. If the application makes use of this shortcut, then runtime errors will be detected and logged when the application attempts to use that shortcut.
WARNING: Unsupported device detected. Shortcut name = "Ethernet Shortcut". Device name = "Interbake_Line_4_1348_Molder". Description: The system has detected that a device type that was not supported in the requested version is referenced by a shortcut. If the system upon which this project is to be run has received a patch that adds support for this device type, then this situation will not cause any problems. Otherwise runtime errors will be detected and logged by the target system when it attempts to communicate to that device.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with warnings. The runtime application has been created.
CAUTION: Running this application might produce errors at runtime.
----------------------------------------------------------------------------------------
What would cause this ?
Thanks so much in advance,