jrexrode
Member
I've got a machine builder wanting to use the AB Micro800 series for an upcoming job. I realize that from a machine builders perspective, the low cost of the hardware is very appealing, but after reading some of the posts on this forum about experiences using the platform, I have my doubts whether this is a good option when looking at it from a plant support view (buggy software, different user interface, different instruction set, etc.).
Most of the negative posts seem to be from at least a couple of years ago, but I wonder if a lot of the issues from then have been addressed.
Also, how useful is the CCW software as a tool for online troubleshooting compared to RSLogix?
Thanks in advance for your input and insight.
Most of the negative posts seem to be from at least a couple of years ago, but I wonder if a lot of the issues from then have been addressed.
Also, how useful is the CCW software as a tool for online troubleshooting compared to RSLogix?
Thanks in advance for your input and insight.