Steve Meisel
Member
I am working on my first Automation Direct project and I have a couple of questions. The plc is a Siemens TI435 and I am adding a analog module to do some measuring of the depth of a metal tube being pressed into a part.
1. Does the processor have any retentive memory? I want to store some numbers from the HMI for the tube depth limits. I would like them to be retained in case of a power failure. Currently I have to hook up the pc to change the limits using a constant.
2. Is there an easier way to clear or zero 4 sequencial V registers than: load 0 out V1505, load 0 out V1506, load 0 out V1507, load 0 out V1510
Thanks,
Steve
1. Does the processor have any retentive memory? I want to store some numbers from the HMI for the tube depth limits. I would like them to be retained in case of a power failure. Currently I have to hook up the pc to change the limits using a constant.
2. Is there an easier way to clear or zero 4 sequencial V registers than: load 0 out V1505, load 0 out V1506, load 0 out V1507, load 0 out V1510
Thanks,
Steve