I am trying to communicate to a Powerflex 525 using a Micro 820 using a MSG instruction over Ethernet. I am using the position UDFB from the AB site. I need to write a few separate MSG's along with the UDFB. I want to change the parameters that define my position steps....
I found a read/write download from AB (Document QA20415) This MSG instruction is set for USINT. I need to write a REAL value. Any idea how to change this without rewriting the constitution?
or
Does anyone know how to add a read or write to an existing UDFB? It would be nice to just add it to the position block from AB. I am concerned about running the UDFB and the MSG at the same time...
Thanks in advance, Chuck
I found a read/write download from AB (Document QA20415) This MSG instruction is set for USINT. I need to write a REAL value. Any idea how to change this without rewriting the constitution?
or
Does anyone know how to add a read or write to an existing UDFB? It would be nice to just add it to the position block from AB. I am concerned about running the UDFB and the MSG at the same time...
Thanks in advance, Chuck