changing 1734-IB4 for a 1734-IB8

winbug

Member
W
Join Date
May 2020
Location
nunspeet
Posts
3
Hello,

I don't have enough inputs on my RIO and would like to replace a 1734-IB4 input card with a 1734-IB8.
What must I change in the configuration of the RIO?
I don't have much experience with changing hardware configurations.
So little help is appreciated.

thanks Jan
 
Thanks for the answer,

How can I change the module in the IO tree, can I select the old one and remove this one and then select the new one?
The old one is in use must i change the input in the program?
 

Similar Topics

C
Changing type of input in 1734-IB8S
Hello, I have a running system where I'm completing an overfill protection logic and noticed that one of my feedback inputs is configured as...
Replies
2
Views
1,506
cardosocea
C
M
Changing a PowerFlex 525.
Hi to all. We need to change a bad powerFlex 525 to a new one. How do you save the configuration to install in the new one? Thank you all for...
Replies
5
Views
207
James Mcquade
J
F
HMI Buttons go to error after changing screens
Hi all, I am having an issue where some of my HMI push Buttons and Indicators go in to error when I navigate to a new screen. I am using a...
2
Replies
16
Views
411
plvlce
P
M
AB Armor block signal lag not changing state.
We have a new machine that uses an armor block to transfer input signals for conveyor position that continuously alarms out on no position change...
Replies
0
Views
80
Mgw1970
M
D
Changing OMRON PLC & HMI IP causing communication break
Hello everyone, I am trying to change the IP address of the Omron PLC (NJ30-1200) and HMI (NB7W-TW01B) to fetch the network on our network...
Replies
7
Views
274
Dshahzad
D
Back
Top Bottom