Hi all, Having an issue with an old Schneider Electric PLC processor TSX P57203. The unit is linked via cable to a Gateway module TSX ETG1010 which in turn is connected via cable to the machine HMI.
The processor has a solid red ERR LED and a solid Amber TER LED illuminated.
The manual description of this LED combination states that a reset is necessary. I have pressed the reset button but nothing has changed.
The Gateway module has a flashing red ERR LED on its display. The manual describes this as a configuration error or the speed between the Gateway module and processor module is different.
Not sure if either or both modules will need to be changed. If the processor has to be changed is it simply a case of removing the memory card from the old one and inserting into the new one once the new processor has been installed on the PLC Rack.
Thanks.
The processor has a solid red ERR LED and a solid Amber TER LED illuminated.
The manual description of this LED combination states that a reset is necessary. I have pressed the reset button but nothing has changed.
The Gateway module has a flashing red ERR LED on its display. The manual describes this as a configuration error or the speed between the Gateway module and processor module is different.
Not sure if either or both modules will need to be changed. If the processor has to be changed is it simply a case of removing the memory card from the old one and inserting into the new one once the new processor has been installed on the PLC Rack.
Thanks.
Last edited: