mainstreetmark
Member
Hi!
I have a DirectLogic 205 with a H2-ERM100, used to connect some remote IO, via a H2-EBC100.
The problem is, they're not communicating. The ERM100 flashes it's error light.
Initially, I was using a crossover cable to directly link the two, but right at this very moment, I have the computer and the two eth modules all connected to a spare, temporary switch. The result is the same:
- Running the ERM Workbench wizard ultimately fails on the "Write to ERM..." step, with a "Timeout" failure.
- NetEdit3 can see both modules (in Hub mode) just fine.
- DoMore won't even let me run without this error being fixed, so I'm kind of held up by it.
Thanks for any advice you all may have.
I have a DirectLogic 205 with a H2-ERM100, used to connect some remote IO, via a H2-EBC100.
The problem is, they're not communicating. The ERM100 flashes it's error light.
Initially, I was using a crossover cable to directly link the two, but right at this very moment, I have the computer and the two eth modules all connected to a spare, temporary switch. The result is the same:
- Running the ERM Workbench wizard ultimately fails on the "Write to ERM..." step, with a "Timeout" failure.
- NetEdit3 can see both modules (in Hub mode) just fine.
- DoMore won't even let me run without this error being fixed, so I'm kind of held up by it.
Thanks for any advice you all may have.