PLC 5/25 switch setting
I have a PLC5/25 connected with 1771-ASB ser B module on Remote I/O port.I am unable to communicate with PLC 5/25 and 1771-ASB module. Both LEDs Active and Fault are blinking at once on 1771-ASB module (it indicates that u should check DIP switch setting).I have connected my PC to PLC 5/25 by 1784-KTX card through DH+ link on programming port.(3 pin DH+ port).
Regarding DIP switches i have following questions
1- SW1 switch8= should be set on Adapter(ON) or scanner (OFF).When Adapter mode is selected and when scanner mode is selected?. Should i use Adapter mode or scanner mode for communicating b/w 1771-AB and PLC5/25.
2- On my Processor (5/25) it is given that on
SW2 switch 1 = OFF (for 57.6Kbs baud rate),
in manual it is given an unused bit.
3- Should i close SW3 swtich 1 =ON (end of Remote I/O node.
Shoud i close SW3 switch 2= ON (End of DH+ node.
4 -Remember i am using 1/2 slot addressing with 32 bits modules . I have 16 slots in my local chassis. so my PLC chassis will occupy rack 0,rack 1 , rack 2 and rack 3.
5- So what address i put of rack number in SW2 (switch 4-8).
What i address i put on 1771-ASB SW1 (switch 1-6).
6- What should i select on SW2 switch 2 (half or full )PLC 5/25 processor.
With regards
M.Salman