Hi,
Please can anyone help me and sort out below issue.
We are building a coil winding machine with servo motor concept
MPL - A230P-VJ72AA
Servo Drive - 2097-V32PRO-LM
PLC - 1769-L18ERM-BB1B
Rotary and linear rotary used
Often we get rotary servo fault and linear servo fault.
We reset in HMI and run the machine.
However, after sometime we get the same error.
1) I tried to remove the motor power (MP) connector and as expected the servo motor stopped running but servo driver indicates error code of <F 55> and manual says F55 is “Excessive velocity error”
2) Under no run condition, I tried to remove the motor feedback (MF) connector and servo drive indicates error code <F05> and the manual says F05 is "Motor over temperature”
I don’t think the above error could be a valid error code for the conditions that we simulated.
Kindly get us the confirmation on error code information and request to fix the above.
We also get FC14 error frequently
Note: manual referred – “Rockwell Automation Publication 2097-UM002C-EN-P - December 2013”
Thanks,
Selvakumar. S
Please can anyone help me and sort out below issue.
We are building a coil winding machine with servo motor concept
MPL - A230P-VJ72AA
Servo Drive - 2097-V32PRO-LM
PLC - 1769-L18ERM-BB1B
Rotary and linear rotary used
Often we get rotary servo fault and linear servo fault.
We reset in HMI and run the machine.
However, after sometime we get the same error.
1) I tried to remove the motor power (MP) connector and as expected the servo motor stopped running but servo driver indicates error code of <F 55> and manual says F55 is “Excessive velocity error”
2) Under no run condition, I tried to remove the motor feedback (MF) connector and servo drive indicates error code <F05> and the manual says F05 is "Motor over temperature”
I don’t think the above error could be a valid error code for the conditions that we simulated.
Kindly get us the confirmation on error code information and request to fix the above.
We also get FC14 error frequently
Note: manual referred – “Rockwell Automation Publication 2097-UM002C-EN-P - December 2013”
Thanks,
Selvakumar. S