![]() ![]() ![]() ![]() ![]() ![]() |
||
![]() |
||
![]() ![]() ![]() ![]() This board is for PLC Related Q&A ONLY. Please DON'T use it for advertising, etc. |
||
![]()
|
New Here? Please read this important info!!!
![]() |
#1 |
Member
![]() ![]() Join Date: Jun 2013
Location: Southampton
Posts: 295
|
Logo8 RTD configuration
Hi,
Can somebody provide a simple example of interrogating a temperature sensor using a Siemens Logo and an AM2 RTD module please? What have so far... My Logo (6ED1 052-1MD00-0BA0) connected to my AM2 RTD module (6ED1055-1MD00-0BA2) In my program I am trying to see how to simply connect and check that my sensor value is actually being read correctly by the Logo. I have a two wire sensor which is wired as follows: Black wire into U1- and IC1 in RTD module Red Wire into U1+ in RTD module What I cannot figure out is how to actually see the reading coming in on the Logo software? I have setup in my software an analogue input contact which is set to AI1 0 however this seems wrong because AI1 is terminal I7 on the logo itself, not the RTD module. Looking around online I cannot find anything that useful. Thanks |
![]() |
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
SLC 5/05 RIO 1747-SN and 1747-ASB Configuration Questions | reese006 | LIVE PLC Questions And Answers | 2 | January 22nd, 2017 02:41 AM |
AI module configuration Error on Redundant ControlLogix5563 system | nibed | LIVE PLC Questions And Answers | 4 | February 6th, 2014 10:28 AM |
XPORT-EIP-MB EtherNet/IP Module Configuration File | mihiri | LIVE PLC Questions And Answers | 0 | May 30th, 2010 11:18 PM |
Pls help | sree46 | LIVE PLC Questions And Answers | 2 | December 13th, 2009 08:36 AM |
PLC5 I/O configuration | bwana_88 | LIVE PLC Questions And Answers | 10 | February 28th, 2009 09:30 AM |