shrirampendse
Member
Hello,
I have a problem with FactoryView SE. For development I was given version 5.1 CPR 9. My application is ready on version 5.1 . But now when the purchased license and its DVD has arrived it is version 5.0 CPR 9. I backed up my application from v 5.1 and restored it in 5.0 But When I open my SCADA application on version 5.0, screens cannot be opened. What is the way out?
(a) Can I use version 5.0 license to run my version 5.1 SCADA application?
(b) How do I convert my 5.1 version application to 5.0 .
No help can be solicited from Local Rockwell support.
Thanks and regards,
CLXenggr
I have a problem with FactoryView SE. For development I was given version 5.1 CPR 9. My application is ready on version 5.1 . But now when the purchased license and its DVD has arrived it is version 5.0 CPR 9. I backed up my application from v 5.1 and restored it in 5.0 But When I open my SCADA application on version 5.0, screens cannot be opened. What is the way out?
(a) Can I use version 5.0 license to run my version 5.1 SCADA application?
(b) How do I convert my 5.1 version application to 5.0 .
No help can be solicited from Local Rockwell support.
Thanks and regards,
CLXenggr
Last edited: