Nearbyatom
Member
I'm looking at mounting a B&B cellular modem on a control panel door. The modem connects to a FA-ISOCON converteing the RS232 signal to a RS485 signal. There is 1 bundle of wire connecting buttons, and temperature controller on the door to the rest of the control panel. In this bundle is 230 VAC (that's what the temperature controller runs off).
Will I get signal distortion and other problems with my RS232 communications if I run it in the same bundle with 230 VAC?
Thanks in advance.
Will I get signal distortion and other problems with my RS232 communications if I run it in the same bundle with 230 VAC?
Thanks in advance.