I have a GE Fanuc 90-30 plc, cpu 351:
this my first GE plc that is in Run mode. no faults at processor. ok and run leds are ON.I am connecting to port 2 at the cpu with a cable (15 pin male to USB). I can upload but can not download. the plc mode most likely has to be stopped to download to it. cpu firmware is 7.01, and I am using PROFICY 8.5. the key switch at the cpu is diabled. i had a copy of the program imported into proficy. the "download target to plc" is greyed out. plc cpu config file when i am connected to plc, the key sw is disabled and does not allow change in proficy. need to download the project in proficy to plc to make both equal. is this firware problem? and how to download?any ideas if there is any thing wrong I am doing?
this my first GE plc that is in Run mode. no faults at processor. ok and run leds are ON.I am connecting to port 2 at the cpu with a cable (15 pin male to USB). I can upload but can not download. the plc mode most likely has to be stopped to download to it. cpu firmware is 7.01, and I am using PROFICY 8.5. the key switch at the cpu is diabled. i had a copy of the program imported into proficy. the "download target to plc" is greyed out. plc cpu config file when i am connected to plc, the key sw is disabled and does not allow change in proficy. need to download the project in proficy to plc to make both equal. is this firware problem? and how to download?any ideas if there is any thing wrong I am doing?