In-Sight series Cognex camera alignment

neilm

Member
N
Join Date
Feb 2019
Location
Jackman
Posts
28
Hello everyone,

PFA. I am not very used to of the Insight system. But this is a general question, Since the 0 line is offset from the right edge of the screen, does it mean that the camera is misaligned?

Thank you,
Neil

Cognex_Alignment.JPG
 

Similar Topics

D
Keyence IV Series Vision Sensor Vs Cognex Insight Series
Does anyone have experience with both these of sensors in regards to ease of use, setup, capabilities, support etc. Any thoughts would be greatly...
Replies
4
Views
5,047
ddnnis
D
tobor
Cognex In-Sight 5000 Series Connection
I have a Cognex In-Sight 5000 Series camera using Ethernet/IP we previously pulled off another machine, with an IP address in the 192.168.0.X...
Replies
7
Views
6,375
benaiahhenry
benaiahhenry
J
RSLogix 5000 and Cognex In-Sight Explorer 5.9 - Will not Read/Write data
Thank you for any and all responses/help. I have an RSLogix 5000 v20 and a Cognex In-Sight v5.9 spreadsheet (8502P). I can not figure out how to...
Replies
0
Views
118
JEM
J
B
Restoring In Sight Job backup on emulator
HI all, I have a backup from a Series 7000 Cognex camera. I am trying to restore and see the vision tools used in the job. Can I restore those...
Replies
0
Views
61
bdauliya
B
N
Cognex Insight communication through EL6652 Beckhoff
Gents, We have the following configuration: A Beckhoff PLC with EthercatMaster > EK1100 with a EL6652 EthernetIP Master. Plan is to...
Replies
2
Views
381
nightline
N
Back
Top Bottom