Elau - sx1

kootni

Member
Join Date
Nov 2018
Location
England
Posts
69
Hi
New to servo motion control. Basically need to configure Elau SX1 motion controller to a servo drive.

How do i go about? i have read ELAU manual but it does not make much sense.

Any other books i can refer to? or sites with practical demos.

Thanks
 
The Elau SX-1 is more than 20+ years obsoleted. You will be hard pressed to find any help on this. I don't entirely understand your question though. Are you trying to program the SX-1 or are you replacing it?
 

Similar Topics

Anybody have EPAS-1 software for programing SX1 ELAU
Replies
5
Views
5,068
hi everybody. i try conect whit max-4 and PacDrive Diagnostics 2.1 but i can´t do. i follow ok steps as next link video but in second 0.41 is my...
Replies
1
Views
1,632
Hello, I'm looking to setup a test rig in the workshop for testing the likes of the following units; Elau MC-4 Servo Drives & Pac Drives...
Replies
2
Views
1,752
hello everyone I need Firmware version V00_22_05 for my MC-4 kan anybody help me, i can't found this file Thanks ans regards
Replies
1
Views
5,077
Some of ELAU SM servo motors utilize SICK STEGMANN encoders of type SRM50. My SM motor had a defective SRM50 and I bought a new one from SICK. I...
Replies
4
Views
2,119
Back
Top Bottom