Hey, I have a SN 6000 setup and I was wondering how to / if I can connect to a controllogix PLC using a 1756-EN2T card.
I have attempted to set it up but I cannot view the device in RSLinx.
I believe how the SN 6000 works is you set the IP Address of the PLC and tell it which port it uses and which port you want that to be externally.
So I set up the PLC IP address in the SN 6000 web interface "Host Redirect (Port Forwarding) Rules" but still no luck.
Any help would be greatly appreciated.
I have attempted to set it up but I cannot view the device in RSLinx.
I believe how the SN 6000 works is you set the IP Address of the PLC and tell it which port it uses and which port you want that to be externally.
So I set up the PLC IP address in the SN 6000 web interface "Host Redirect (Port Forwarding) Rules" but still no luck.
Any help would be greatly appreciated.