2D Data Matrix - separating out data

tspisak

Member
T
Join Date
Aug 2005
Location
Corning, NY
Posts
72
Has anyone read a long 2D data matrix (200+ characters) and separated out the data in to different fields (~twenty)?

I plan on adding a comma to indicate the start of a new field but I don't know where to start programming. The data is a recipe so the data types for each field will stay the same from code to code but the length will not (long and short strings).

I am using a Keyence SR-651 barcode scanner connected to a A-B CompactLogix processor via Ethernet IP.

Any tip on getting started?
 

Similar Topics

Sparky
Data matrix reader configuration
What kind/brand of 2D data matrix readers are the easiest to set up and communicate with CompactLogix PLC? I'm looking to install and setup...
Replies
4
Views
2,203
Sparky
Sparky
A
reading data from siemens controller (profinet) to ethernet/IP controller
Hello I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Replies
3
Views
36
Manglemender
M
P
WinCC RT Advanced - Data Logging Memory
Hi folks, I'm not as accustom with Siemens & WinCC, however I've been asked to increase the amount of data an existing application is logging...
Replies
2
Views
65
Plantationpark
P
P
Migrating Proficy Historian data to a new server (essentials edition)
Has anyone migrated Proficy Historian data to a new server? I followed the guide to move all the data over, but when I run the utility, it stops...
Replies
0
Views
45
phuz
P
U
SLC500 analog input value data type for EZ Series HMI
I cannot add SLC500 analog input tag (I: 8.3) to EZSeries Touch Panel Editor (V 5.3). I used all the listed tag datatype but it all says "Invalid...
Replies
10
Views
257
OkiePC
OkiePC
Back
Top Bottom