Hello,
We have a Sinamics S110. A while ago we had some troubles with drivecliq and we even needed the assitance from Siemens experts. It was the drivecliq chip that was broken. While they searched for the problem, they exchanged the CU.
Now, months later I need to change a parameter on the drive. But I cannot connect !! I can see the node and I get the alarmmessage that the device (CU305) is not compatible when connecting.
I Had DriveES with Starter v4.1+ SP3.
I now installed 4.2 + SSP Sinamics 4.4
Same problem, still uncompatible.
Any ideas what can be done to solve this issue ?
Kind regards,
Combo
We have a Sinamics S110. A while ago we had some troubles with drivecliq and we even needed the assitance from Siemens experts. It was the drivecliq chip that was broken. While they searched for the problem, they exchanged the CU.
Now, months later I need to change a parameter on the drive. But I cannot connect !! I can see the node and I get the alarmmessage that the device (CU305) is not compatible when connecting.
I Had DriveES with Starter v4.1+ SP3.
I now installed 4.2 + SSP Sinamics 4.4
Same problem, still uncompatible.
Any ideas what can be done to solve this issue ?
Kind regards,
Combo