Cx programmer pid and tpo program help

Hello

Can someone please help me make a program to cj1m omron plc.

Hardware: cj1m cpu 12

ad041 v1, id211, oc211,od212

I will use the plc to my homebrew setup. I have a solid-state relay which I want to heat water with. I think I need a program with pidat and a tpo instruction.

Earlier i have just used pid functionsblock, bit it did not work with the old plc. With omrons pid instruction theres some parameters i need to set. I dont understand how.
I guess this is an easy job for you guys

First,
Welcome to the forum.


Please see the attached files. This information is from the W340 Instruction Reference manual for the CJ/CS series plc's.


This should provide the information you are looking for.