I'm wondering if anyone has experience communicating with Danfoss ECL Comfort 310 controller through Modbus TCP/IP. I have a project where I have to include a heating substation into Ignition Edge, but the existing substation is run by ECL 310 controller. There is a Modbus communication manual with listed parameters for ECL, but I can't work out what Modbus addresses of parameters should be. Every parameter has a unique ID, which range from 11000 to 14500 for specific application, which baffels me when comes to translating this to Modbus.
Danfoss ECL Comfort 310 Modbus
- Thread starter *bj
- Start date
Similar Topics
Hey guys.
As the title suggests, I need to configure a Danfoss Aquadrive FC202 inverter, so that its logic inhibits the local command when the...
Hi all,
We are currently experiencing an DC over voltage fault on one of our inverters. During commissioning a snag was raised whereby excess...
hey guys i've been trying to find an updated SW files of my danfoss fc360 for MCT 10 software but i couldnt be able to find it anywhere on...
Hello all. I am hoping someone here has installed a Danfoss VLT Midi FC 280 and connected an encoder to it. I am just trying to make sure I select...
Good morning!
I'm trying to communicate a Micro 850 (2080-LC50-AWB) with a Danfoss FC202 by VLT 121 MCA Ehternet ip card.
I can read the value...