smelese
Member
how many output modules should you connect to a Point I/O 1734 AENTR?
1734-aentr
- Thread starter smelese
- Start date
the_msp
Lifetime Supporting Member
Welcome to the forum!
How many do you need...?
There are rules on how many you can add before you need to add more rack power modules, this depends on the card types in the rack
See this thread for detailed information: http://www.plctalk.net/qanda/showthread.php?t=91910&highlight=point+capacity
How many do you need...?
There are rules on how many you can add before you need to add more rack power modules, this depends on the card types in the rack
See this thread for detailed information: http://www.plctalk.net/qanda/showthread.php?t=91910&highlight=point+capacity
http://www.plctalk.net/qanda/showthread.php?t=91910
http://www.plctalk.net/qanda/showthread.php?t=81438
The above threads may help you out.
Regards,
http://www.plctalk.net/qanda/showthread.php?t=81438
The above threads may help you out.
Regards,
Ken Roach
Lifetime Supporting Member + Moderator
Welcome to the PLCTalk forum community !
Don't overlook the official documents for those products, including the A-B website and the POINT I/O Selection Guide.
If you frequently bid or design systems with POINT I/O, the Rockwell "Integrated Architecture Builder" design tool also helps you select and scope (power supplies, network load, module count) POINT I/O systems.
Don't overlook the official documents for those products, including the A-B website and the POINT I/O Selection Guide.
If you frequently bid or design systems with POINT I/O, the Rockwell "Integrated Architecture Builder" design tool also helps you select and scope (power supplies, network load, module count) POINT I/O systems.
Similar Topics
Hello
The plant is running and there is no shutdown nowadays therefore I can add 1734- AENTR and its card while PLC is in Run?
I do not wanna...
Hello all.
I have a remote that uses a 1734-AENTR series C.
We had to change it to a new one and, after adjusting the IP and number of slots...
The issue we have is that the IT2I thermocouple card and the RTD temperature sensor card connected through a point IO AENTR is constantly trying...
Hi guys, I have just recently purchased a 1734-AENTR module so that I could learn how to configure it through LogixDesigner and establish comms...
Hi there!
I've been looking for some fault codes table for the 1734-AENTR adapters, since I'd like to show a message in HMI with some...