Variblade
Member
I am using up/down counters for some position control. I would like to be able to change the value of the counter to 25 when a limit switch is activated. Anyone have any ideas on how this can be done?
Up/down counter values
- Thread starter Variblade
- Start date
rogerhollingsworth
Member
In using A-B plc instructions you could use a MOV instruction and move 25 into the counter ACC. or PRE.
Last edited:
Similar Topics
I am using LOGO Soft Comfort V8.1
I am trying to reset a UP/Down Counter when it reaches a certain value but I can not find the way to do it, does...
I am new to PLCs just started doing this about a month ago. I want to write a ladder program using directsoft5 for DLO6 . The program should have...
Hi to all, i am newbie on plc.
I would like to make a down counter with preset value 3.
Counter from 3 must goes to 2 after 2min, from 2 to 1...
Here's the situation: operators print off labels for finished products, scan the barcode on the label, apply the label to the products and place...
hi,
I am working on mitsubishi PLC Fx1N. I have a table of rollers driven by a motor. Table length is 3 mtr and width is 2 mtr. this table is a...