kenetix350 current feedback

JFelectric

Member
Join Date
Apr 2014
Location
BC
Posts
11
looks like the SI guys only did basic setup of out plants kenetix 350 drive on actuators.

im trying to trend current feedback, but it looks like the AXIS.CurrentFeedback tag doesn't change from zero during movement.

how would i go about pulling that info?

thanks!
 
Open the Axis Properties under Drive Parameters, make sure anything you want is checked.

gksODt7.png
 

Similar Topics

Today I was working on my project for school and we were using a power supply with 24V and we accidentally had the current at 0.9A. We heard a pop...
Replies
9
Views
465
Hi all, I have been working on a project that requires me to measure the current across a 90 VDC motor of a medical device (similar to an...
Replies
22
Views
1,188
HI i have a delta VFD M-series in the manual, in order to enter the motor rated current you set the parameter P,52 =the motor rated current my...
Replies
7
Views
617
HI! HOW COULD I OBTAIN THE NAMES OF THE STEPS OF A ROUTINE IN SFC LANGUAGE IN STUDIO5000? Or is there a system variable that gives me those...
Replies
0
Views
310
VFD is not tripping at higher current , resulting in motor failure . VFD Model : Make - KEB Type - H6- 10H6BBBB-21B0
Replies
2
Views
487
Back
Top Bottom