OMRON C200HW-PRM21 communication cable

kalabdel

Member
K
Join Date
Feb 2015
Location
Ontario
Posts
1,108
Hello guys,

I need to change the configuration on an C200HW-PRM21
PROFIBUS-DP Master Unit and looking communication cable. Any one knows where to get one? Is there another way to configure the module or is this the only way?


Thanks
 

Similar Topics

S
omron c200hw-drm21-v1 problem
need help, Hi i'm new. My deviceNet master drm21-v1 show an error, E2, then the whole system will power off. The power supply come back...
Replies
1
Views
2,755
Jay Anthony
Jay Anthony
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
2
Views
23
Steve Bailey
Steve Bailey
M
Struggling to get good connectivity with Omron PLC (CS) and KeserverEx
Hi There, I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Replies
4
Views
99
Mihir_007
M
A
Omron cj1m ETN cpu11 connection with NT631C
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
Replies
7
Views
117
James Mcquade
J
K
Omron AD081-V1 Analog Input Card Calibration (Offset & Gain Adjustment)
Omron AD081-V1 Analog Input Card Offset & Gain Adjustment Entering Adjustment Mode 1. Set the input card in adjustment mode (Turn ON Dip SW No-1)...
Replies
0
Views
56
Ko Lin
K
Back
Top Bottom