Controller Data Exchange

ABnorm123

Member
A
Join Date
Sep 2022
Location
New Zealand
Posts
3
Hi,

Has anyone tried here to work with Mitsubishi FX3U as controller 1(connected thru serial) for Mitsubishi HMI E1071 then AB Compactlogix as controller 2(connected thru ethernet).

I'm talking about the Controller data exchange between 2 controllers(Dual Drivers) feature on E-designer.
 
I have done this from an FX2N, FX3U & SLC505 works well.
Been some time but see pic. Just remember, the E series is now not supported as it is end of life. Never done it to CLX but it should work.

PLC_PLC.png
 

Similar Topics

M
Data exchange between Rockwell(AB) compact logix series controller and Siemens IM-151
Hi there, Can anyone suggest the solution to communicate between AB Compactlogix L36ERM controller(Which is having remote flex IOs over ethernet)...
Replies
9
Views
3,643
Ken Roach
Ken Roach
A
Beckhoff CX Controller and AB SLC500 Data Exchange
I know there are not a lot of Beckhoff TwinCAT users on here, but I wanted to share this with anyone that may have a need for it...
Replies
9
Views
5,380
Archie
A
A
reading data from siemens controller (profinet) to ethernet/IP controller
Hello I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Replies
5
Views
90
bkottaras
B
E
Modbus serial data from multiple devices to M340 controller
I have 9 field devices, three METSEPM5110 power meters and six ACE949-2 rs285 interface modules. I want to read this Modbus rtu data through rs485...
Replies
8
Views
315
Enggshab
E
Lovell
Produce/Consume data from a WAGO 750-881 with a CompactLogix controller
I have been trying to setup a connection between a 1769-L33ER and a WAGO 750-881. The WAGO PLC is part of vendor equipment. I set up a Generic...
Replies
0
Views
1,156
Lovell
Lovell
Back
Top Bottom