Techmatic.Mathias
Member
Hello there
I have some issues connecting to EtherCAT based stepper motor controllers.
The controllers are RTA CSD ET and the manufacturer have made a guide on how to connect using TwinCAT 2.
So i have connected a PC using an ethernet cable, installed the TwinCAT Ethernet driver (which replaces, or modifies the Adapter driver).
Then i insert an EtherCAT device in a new TwinCAT System Manager project, and choose the EtherCAT NIC as adapter.
When i press "scan boxes" under "I/O Devices - Device 1" i get the following error: Init2\IO: Create TComObj SAFEOP >> AdsError: 1793 (0x701, 'ADSERROR: service is not supported by server')
So i a basically looking for someone with knowledge about TwinCAT/EtherCAT.
Thanks in advance!
I have some issues connecting to EtherCAT based stepper motor controllers.
The controllers are RTA CSD ET and the manufacturer have made a guide on how to connect using TwinCAT 2.
So i have connected a PC using an ethernet cable, installed the TwinCAT Ethernet driver (which replaces, or modifies the Adapter driver).
Then i insert an EtherCAT device in a new TwinCAT System Manager project, and choose the EtherCAT NIC as adapter.
When i press "scan boxes" under "I/O Devices - Device 1" i get the following error: Init2\IO: Create TComObj SAFEOP >> AdsError: 1793 (0x701, 'ADSERROR: service is not supported by server')
So i a basically looking for someone with knowledge about TwinCAT/EtherCAT.
Thanks in advance!