Hi Everyone,
Looking for a "Sanity Check" on my programming for Starting and Stopping a pump connected to a SMC-3 Flex Soft Starter via Ethernet/IP. I have never used EIP with a Flex before so I want to make sure I am on the right track.
I am basically using the same logic that I use with a Powerflex VFD. I set the Start Bit until the Running Bit is true. Then I set the Stop Bit until the Stopping Bit is true. I have 2 diffrent devices that can request the pump to run so I have the Start Request's OR'd together and the Stop Request AND'd together.
Give me your thoughts on this.
Thanks!!
Looking for a "Sanity Check" on my programming for Starting and Stopping a pump connected to a SMC-3 Flex Soft Starter via Ethernet/IP. I have never used EIP with a Flex before so I want to make sure I am on the right track.
I am basically using the same logic that I use with a Powerflex VFD. I set the Start Bit until the Running Bit is true. Then I set the Stop Bit until the Stopping Bit is true. I have 2 diffrent devices that can request the pump to run so I have the Start Request's OR'd together and the Stop Request AND'd together.
Give me your thoughts on this.
Thanks!!