Dear all,
Recently i found Weintek HMI and its software Easybuilder 8000. Now i want to communicate Weintek MT6050i HMI with Allen Bradley Micrologix 1200 controller.
I am facing following problems,
The address n10:10/08 is unknown for EasyBuilder 8000, while this is an alarm bit in micrologix 1200 controller.
So how can i insert n10:10/08 in Weintek HMI?
Currently i am using bit lamp in Easybuilder 8000 software.
Recently i found Weintek HMI and its software Easybuilder 8000. Now i want to communicate Weintek MT6050i HMI with Allen Bradley Micrologix 1200 controller.
I am facing following problems,
The address n10:10/08 is unknown for EasyBuilder 8000, while this is an alarm bit in micrologix 1200 controller.
So how can i insert n10:10/08 in Weintek HMI?
Currently i am using bit lamp in Easybuilder 8000 software.