ABB/Entrelec Terminals

Old No. 7

Member
O
Join Date
Jun 2010
Location
Ohio
Posts
173
A little off topic here, but...

Does anyone use Entrelec terminal test adapters (DCO and DCJ)? If so does anyone stock them? I've searched all over and it seems like everyone has a 7-8 week delivery on something you would think are made by the tens of thousands.

I also have some concern about the DCO's not fitting the terminals we use properly as we've had some not fit right even though the catalog says they are the right ones.
 

Similar Topics

EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
85
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
131
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
207
BryanG
B
R
ABB AC500 (PM573-Eth) PLC Program Backup
Hello all, I have an ABB PLC (PM573) and it has without MC card. I need to take backup from PLC to PC (in automation builder v2.7 ). My...
Replies
10
Views
429
arpus4KM
A
O
Remote Connection to ABB MOD300 OPC Server - Difficult or Impossible
Folks, I have a client with an old ABB Advant / MOD300 system (v14.4). Around y2k I installed the ABB Industrial IT MOD300 OPC Server 1.1/2...
Replies
1
Views
178
odwyerpw
O
Back
Top Bottom