talldude42
Member
I am having with voltage on an issue with the automation direct productivity 3000 p3-08tas output card. The out out is wired to 120v, which is the signal voltage to a solid state delay with 480v on the load side. With the the output off, On 4 of 6 outputs I get 20v on the terminals, and the other 2 I have 58v which is apparently enough to activate the relay. I swapped out the relay and same result. Another thing I can't seem I place is it I remove the the common from the relay, turn off the output I get 120v to the relay.
This is all new equipment, fresh build but I have built 6 units this exact same way and didn't have this issue.
Any ideas? Thanks for your time people.
This is all new equipment, fresh build but I have built 6 units this exact same way and didn't have this issue.
Any ideas? Thanks for your time people.