SolarNinja
Member
Hi, thanks in advance all for reading. I'm automating my lathe and I am using my AB CompactLogix L45 PLC as control. I followed the basic steps in RSLinx, here is what I did exactly:
Deleted all drivers.
Added EthernetIP driver.
Selected the fast ethernet driver, not the wireless one.
Ethernet cable is connecting laptop to EthernetIP module.
I open RSWho
I can see the EthernetIP driver in RSWho, but when I try to expand it, it just scans.
I opened the command prompt and tried to ping the IP address shown on the Ethernet IP module display, and 4 packets sent, 0 packets received, 4 packets lost, 100% packets lost.
It must be some sort of IP address/subnet mask issue, but I can's for the life of me figure out how to get it working. Any help is very much appreciated. Thanks!
Deleted all drivers.
Added EthernetIP driver.
Selected the fast ethernet driver, not the wireless one.
Ethernet cable is connecting laptop to EthernetIP module.
I open RSWho
I can see the EthernetIP driver in RSWho, but when I try to expand it, it just scans.
I opened the command prompt and tried to ping the IP address shown on the Ethernet IP module display, and 4 packets sent, 0 packets received, 4 packets lost, 100% packets lost.
It must be some sort of IP address/subnet mask issue, but I can's for the life of me figure out how to get it working. Any help is very much appreciated. Thanks!