rdrast
Lifetime Supporting Member
Does anybody have any knowledge of oddities with the SSD 890 AC Drives? Both compact/bookshelf, and monstrous stand alone ones have the habit of losing configuration parameters through a power-down cycle.
In specific, two parameters, one every time, one most times: Seq & Ref "Aux Enable" (Every time) and "Reverse" (some times).
I've burned new firmware, in one case, even changed the entire drive, but the problem remains. And not on all drives, just a few. I've disconnected the comms modules (ControlNet), cycled power, and the parameters change. Nothing seems to make them stick (no, "Parameter Save" or "Application Save" don't do the trick either).
I'm probably going to call Parker about this today, just wondering if anyone else has the issue.
In specific, two parameters, one every time, one most times: Seq & Ref "Aux Enable" (Every time) and "Reverse" (some times).
I've burned new firmware, in one case, even changed the entire drive, but the problem remains. And not on all drives, just a few. I've disconnected the comms modules (ControlNet), cycled power, and the parameters change. Nothing seems to make them stick (no, "Parameter Save" or "Application Save" don't do the trick either).
I'm probably going to call Parker about this today, just wondering if anyone else has the issue.